Products | Machine Tools | FUJI MACHINE MFG



		Products Products Model Selection Guide Support Retool Test Cut Global Support Support Show Information Contacts

Chuck details

TE Series I. D. Collet Chuck Pull back type

I.D. Clamp

High clamping force is achieved by pulling workpiece in full contact with locator surface.
Since workpiece uplift is not present, good parallelism and perpendicularity are achieved.
Centrifugal force is not affected by high spindle speed.
Air through design for workpiece seating confirmation is available as required.

Usage example - TE Series


Toriboard TE25	Differential gear case TE35	Gear spline TE50

Model No.	TE18(3)	TE22(3)	TE25(6)	TE30(3)	TE35(3)	TE40(3)
Jaw Stroke (dia.) mm	0.9	1.1	1.1	1.1	1.1	1.7
Plunger Stroke mm	5	5	5	5	5	5
Clamping dia.(Max.) mm	18	22	25	30	35	40
Clamping dia.(Min.) mm	14	18	22	25	30	35
Max. Draw bar Pull Force kN	32.5	32.5	32.5	32.5	32.5	32.5
Max. Clamping Force kN	116.9	113.2	113.2	111.7	111.7	108.7
Max. Speed min^-1	5000	4000	4000	3000	3000	3000
GD² kgf･m²	0.21	0.37	0.37	0.85	0.85	1.65
Weight kg	15	20	20	32	32	45

Model No.	TE50(5)	TE60(5)	TE70(5)	TE85(5)	TE100(6)	TE120(6)
Jaw Stroke (dia.) mm	1.1	1.2	1.2	1.2	1.2	1.4
Plunger Stroke mm	5	5	5	5	5	5
Clamping dia.(Max.) mm	50	60	70	85	100	120
Clamping dia.(Min.) mm	40	50	60	70	85	100
Max. Draw bar Pull Force kN	15.0	21.2	21.2	21.2	21.2	21.2
Max. Clamping Force kN	32.2	47.0	47.0	47.0	47.0	47.0
Max. Speed min^-1	5000	3500	3500	3500	3500	3500
GD² kgf･m²	0.17	0.5	0.5	0.5	0.55	0.55
Weight kg	13	17	17	17	25	25

(slit number)


		Please contact us for a quote or with any questions.

Products Support Solution Show Information Contacts